Table of Contents
Advertisement
Remote Control
This section describes using the remote control features of the
DTP CrossPoint 4K Series. Topics that are covered include:
•
Selected SIS Commands
Installing and Starting the Control Programs
•
Accessing the HTML Pages
•
Selected SIS Commands
You can use Simple Instruction Set (SIS) commands for operation
and coniguration of the switchers (see
Response Table for Matrix Switcher Commands
You can run these commands from the PC connected to an
Ethernet port
on page 10), or USB port
Establishing a Network (Ethernet) Connection
NOTE:
port, you may need to change the default settings (IP address,
subnet mask, user name, and administrator or user password)
of the IPCP controller or switcher.
Establish a network connection as follows:
1.
Open a TCP socket to port 23 using the switcher IP address.
NOTE:
The switcher responds with a copyright message including the
name, irmware version, and part number of the product, and
the current date and time.
NOTES:
2.
If necessary, enter the appropriate password.
If the password is accepted, the switcher responds with
User
If the password is not accepted, the
reappears.
22
DTP CrossPoint 4K Series • Remote Control
(item
Q
or
The first time you connect to the switcher via the LAN
The factory default IP address is 192.168.254.254.
If the switcher is not password-protected, the device is
•
now ready to accept SIS commands.
If the switcher is password-protected, a password
•
prompt appears.
or
Login Administrator
SIS Command and
R
on page 10), serial port
item
(item
A
on page 16) on the switcher.
.
Password
on page 24).
(item
S
Login
prompt
Advertisement
Table of Contents
