Extron electronics DTP CrossPoint 4K Series Setup Manual page 22

ATTENTION:
•
•
•
•
•
•
NOTE:
following:
•
•
•
•
Local and Mic/Line audio connectors
Figure 15 shows how to wire each audio type. Use the supplied
tie-wrap to strap the cable to the extended tail of the connector.
Do not tin the wires!
Figure 15.
14 DTP CrossPoint 4K Series • Installation
Do not connect these boards to a computer data or
telecommunications network.
Ne connectez pas ces port à des données informatiques ou
à un réseau de télécommunications.
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV
UTP cable or STP201 cable to link the matrix switcher to
Extron DTP products, XTP matrix switchers, or
HDBaseT-enabled devices.
N'utilisez pas le câble AV Skew-Free UTP version améliorée
UTP23SF-4 ou le câble STP201 pour relier la grille de
commutation aux produits DTP, aux grilles de commutation
XTP ou aux appareils équipés HDBaseT Extron.
To ensure FCC Class A and CE compliance, STP cables
and STP connectors are required.
Ain de s'assurer de la compatibilité entre FCC Classe A
et CE, les câbles STP et les connecteurs STP sont
nécessaires.
When using cable in bundles or conduits, consider the
Do not exceed 40% ill capacity in conduits.
Do not comb the cable for the irst 20 meters, where cables
are straightened, aligned, and secured in tight bundles.
Loosely place cables and limit the use of tie wraps or hook
and loop fasteners.
Separate twisted pair cables from AC power cables.
Tip
Sleeve
Tip
Sleeve
Unbalanced Stereo Input
Tip (+)
Gnd (Sleeve, )
Unbalanced Mono (Mic) Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Stereo Output
Audio Input and Output Connector Wiring
Tip
Ring
Sleeves
Tip
Ring
Tip (+)
Ring (–)
Gnd (Sleeve, )
Jumper
Balanced Mono (Mic) Input
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
Balanced Stereo Input