System Configuration; Applicable Systems - Mitsubishi Q62DA User Manual

2 SYSTEM CONFIGURATION

2 SYSTEM CONFIGURATION

2.1 Applicable Systems

2
2 - 1
This section describes the system configuration for the D/A conversion module.
(1) Applicable module and the number of modules that can be installed
The following are the CPU module and network module (for remote I/O stations)
in which the D/A conversion module can be installed and the number of modules
that can be installed.
Applicable module
Q02CPU
Q02HCPU
Q06HCPU
Q12HCPU
CPU module
Q25HCPU
Q00JCPU
Q00CPU
Q01CPU
QJ72LP25-25
QJ72BR15
Network module
QJ72LP25G
QJ71LP25GE
1 See User's Manual (Function Explanation, Program Fundamentals) for the CPU module to use.
2 See Q Corresponding MELSECNET/H Network System Reference Manual (Remote I/O
network).
(2) Base unit in which the conversion module can be installed
The D/A conversion module can be installed in any I/O slot ( 3) of the base unit.
However, a power shortage may occur depending on the combination with other
installed modules and the number of modules used, so always take into
consideration the power supply capacity when installing modules.
3 Limited to the range of the number of I/O points in the CPU module and network module (for
remote I/O stations).
(3) Compatibility with a multiple PLC system
First read the QCPU (Q mode) user's manual (Function Explanation, Program
Fundamentals) if the D/A conversion module is used with a multiple PLC system.
(a) Compatible D/A conversion module
Use a D/A conversion module with function version B or higher if using the
module in a multiple PLC system.
(b) Intelligent function module parameters
Perform PLC write of the intelligent function module parameters to the
control PLC of the D/A conversion module only.
Number of modules that
can be installed
Can be installed in Q mode only
Maximum 64
1
( )
Maximum 16
Maximum 24
MELSECNET/H Remote I/O
Maximum 64
station (
MELSEC-Q
Remarks
1
( )
2
)
2 - 1