Advertisement
XL-R2010BK
Disassembly method
<Main body>
Removing the top cover (See Fig.1)
1.
Remove the four screws A on both sides of the body.
2.
Remove the two screws B on the back of the body.
3.
Remove the top cover from behind in the direction of
the arrow while pulling its sides outwards. Disengage
the three joints a with the front panel section.
Removing
the
mechanism section (See Fig.2 to 5)
Prior to performing the following procedure, remove
the top cover.
1.
Insert a Philips screwdriver into the hole of the
chassis base on the bottom and turn it as shown in
the figure. The tray will move forward.
2.
Pull out the tray manually.
3.
Release the joint b on each side of the fitting
upward, then remove the fitting from the tray.
4.
Push and return the tray.
CD mechanism assembly
Front panel assembly
1-6
fitting
of
the
Tray
Fig.5
Joints a
A
2
A
CD
Front panel assembly
CD mechanism assembly
Front panel assembly
Joint b
Fitting
Top cover
B
2
Fig.1
(Bottom)
Hole of the CD mechanism
section to pull out the tray
Fig.2
Fitting
Fig.3
CD mechanism assembly
Joint b
Tray
Fig.4
Advertisement
