JVC XL-R2010BK Service Manual page 14

Cd/cdr multiple compact disc recorder

Hide thumbs Also See for XL-R2010BK:

Enlarged version

XL-R2010BK

Removing the mechanism board

Reference:The mechanism board can be removed

without removal of the traverse

mechanism assembly.

Note: Before disconnecting the flexible wire coming

from the pickup from the connector, be sure to

solder its shorting round.

If the flexible wire is connected without

soldering, it may cause breakdown of the

pickup.

1. Solder the shorting round of the flexible wire

connected with the mechanism board from the back

of the mechanism assembly.

2. Disconnect the flexible wire from the connector

CN601 on the mechanism board.

3. Remove the three screws C attaching the

mechanism board.

4. Unsolder the two points of the part h and two point

of the part i of the mechanism board. Then, remove

the mechanism board upwards.

Note: When reinstalling the mechanism board,

connect the flexible wire coming from the

pickup to the connector first and then remove

the solder from the shorting round of the

flexible wire.

1-14

(See Fig 10)

Soldered

part h

Flexible wire

Soldered part i

Fig. 10

Shorting round

CN601 on

mechanism

board