Disassembly Method; Main Body - JVC XV-SA600BK Service Manual

Dvd audio/video player

Hide thumbs Also See for XV-SA600BK:

Instructions manual (85 pages)

Table of Contents

2.1 Main body

2.1.1 Removing the top cover (see Fig.2-1)

(1) Remove the two screws A attaching the top cover

on both sides of the body.

(2) Remove the three screws B attaching the top

cover on the back of the body.

(3) Remove the top cover from the body by lifting

the rear part of the top cover.

ATTENTION:

Do not break the front panel tab fitted to the top cover.

2.1.2 Removing the surround audio board (see Fig2-1,2-2)

• Prior to performing the following procedure,remove the top cover.

(1) Remove the three screws C attaching the surround audio

board on the rear panel.

(2) Disconnect the card wire from connector CN711 on the

surround audio board.

(3) The surround audio board is removed while picking up the

point of the fastener in two places.

2.1.3 Removing the mechanism assembly (see Fig2-2,2-3)

• Prior to performing the following procedure, remove the top cover.

• There is no need to remove the front panel assembly.

(1) Remove the three screws D attaching the mechanism

assembly on the bottom chassis.

(2) Remove the two screws E attaching the lug wire and main

board on the bottom chassis.

(3) The servo control board is removed from the

connector CN512 and CN513 connected with the main

board respectively.

(4) Remove the mechanism assembly by lifting the rear part

of the mechanism assembly.

2.1.4 Removing the servo control board (see Fig.2-4)

• Prior to performing the following procedure, remove the top

cover and mechanism assembly.

(1) Disconnect the card wire from connector CN201 and

CN202 on the servo control board respectively.

(2) Disconnect the flexible wire from connector CN101 on the

servo control board from pick-up.

< ATTENTION >

At this time, please extract the wire after short-circuited

of two places on the wire in part a with solder.

Please remove the solder two places of part a after

connecting the wire with CN101 when reassembling.

(3) Two places in hook b are removed, the servo control

board is lifted, and it is removed.

SECTION 2