Advertisement
XV-S56BK/XV-S57SL
Disassembly method
<Main body>
Removing the top cover (see Fig.1)
1.Remove the two screws A attaching the top cover
on both sides of the body.
2.Remove the three screws B attaching the top cover
on the back of the body.
3.Remove the top cover from the body by lifting the
rear part of the top cover.
ATTENTION: Do not break the front panel tab
fitted to the top cover.
Removing the surround audio board
* Prior to performing the following procedure, remove
the top cover.
1.Remove the three screws C attaching the surround
audio board on the rear panel.
2.Disconnect the card wire from CN711 on the surround
audio board.
3.The surround audio board is remove while picking
up the point of the fastener in two places.
Removing the mechanism assembly
* Prior to performing the following procedure, remove
the top cover.
* There is no need to remove the front panel assembly.
1.Remove the three screws D attaching the mechanism
assembly on the bottom chassis.
2.Remove the two screws G attaching the lug wire with
main board.
3.The servo control board is removed from the connector
CN961 and CN701 connected with the main board
respectively.
4.Remove the mechanism assembly by lifting the rear part
of the mechanism assembly.
1-6
(see Fig.1,2)
Fastener
(see Fig.2,3)
Main board
A x 2
B
Lug wire
G
D
CN703
CN711
D
Mechanism
assembly
CN701
Fig.3
B
B
C
C
C
Fig.1
D
CN702
G
Fig.2
CN961
Servo control
board
Advertisement
