Recording From Video Components - Pioneer Elite VSX-21 Operating Instructions Manual

Recording from Video Components

The following operations show you how to record audio and video to the video tape recorder connected to the VCR 1 or
VCR 2 jacks.
The receiver's volume, balance, tone (BASS, TREBLE, and LOUDNESS), and surround effects have no effect
memo
on the recorded signal.
TV
RECEIVER
FQ
+
ENTER
–
FQ
VOL VOL
CHANNEL
MULTI CONTROL
CD
DVD/LD TV/SAT
VCR 1 TUNER
TV CONTROL
VCR 2 MD/TAPE
RECEIVER
DSP MODE MIDNIGHT
1 2 4
3
CH.SELECT
TEST TONE ATT SIG.SELECT
6
5 7 8
CN.LEVEL EFFECT
9
0 +10
MEMU
CLASS TV/VCR
1
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
SIGNAL SELECT
1
1
Select the component you want to record.
Be sure to press SIG. SELECT on the remote or SIGNAL SELECT on the
front panel to choose "ANALOG". (Refer to "Switching ANALOG/
DIGITAL signal input" on page 29.)
2
Prepare the program source.
(Load the DVD or LD, etc.)
3
Insert a blank tape into the video tape recorder (VCR 1).
4
Start recording on the video tape recorder, then start
SIG. SELECT playback from the source component.
memo
• Recording cannot be made from analog to digital, and similarly
from digital to analog.
• When recording a DVD, the recorded image may flicker or be
difficult to view because of the copy protection signal
programmed on the DVD.
Other Operations
43
<ARB7181>