Playing Sources With Dolby Digital Or Dts Sound - Pioneer Elite VSX-21 Operating Instructions Manual

Sound Modes

Playing Sources with Dolby Digital or DTS Sound

RECEIVER
FQ
+
ENTER
–
FQ
VOL
5
CHANNEL
MULTI CONTROL
DVD/LD TV/SAT
VCR 1
TV CONTROL
VCR 2 RECEIVER
DSP MODE
3
1 2 3
CH.SELECT
TEST TONE ATT SIG.SELECT
2 6
5 7
CN.LEVEL
9 0 +10
CLASS
FUNCTION DIRECT
MODE CHECK
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
memo
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the AC-3 RF output, a commercially available RF demodulator
(RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which is then processed by the
receiver at the digital input jacks. For more details, refer to the instruction manual supplied with the RFD-1.
Refer to pages 52, 53 for explanations of Dolby Digital, Dolby Pro Logic, and DTS.
30
<ARB7181>
TV
1
Follow steps 1 to 3 of the playback procedure. (Refer to
"Playback" on page 40.)
1
2
VOL
3 Press FUNCTION to select the source component you want to play.
CD
2
Press SIG.SELECT on the remote control or SIGNAL
TUNER
MD/TAPE SELECT on the front panel to select DIGITAL.
MIDNIGHT
4
(Refer to "Switching ANALOG/DIGITAL signal input" on the previous
page.)
8
EFFECT
MEMU
TV/VCR
3
FL DIMMER
Press
COMMANDER
SET UP
Each press changes the Dolby/DTS mode.
Î
(Refer to "Switching the Dolby/DTS mode" on page 32.)
4
Start playback of the component you selected in step 1.
5
Press VOL (+/–) to adjust the volume level.
3
memo
• When an LD or CD player compatible with DTS is played back with
SIGNAL SELECT set in "ANALOG", digital noise is output caused by
playing back the DTS directly (no decoding). To prevent noise, you need to
make digital connections (Refer to pages 20, 21) and set SIGNAL SELECT
to "DIGITAL".
2 5
Turn on the power of the playback component.
Press RECEIVER to turn on the receiver.
to switch the Dolby/DTS mode on.