Clearing The Remote Control Settings - Pioneer Elite VSX-21 Operating Instructions Manual

Clearing the Remote Control Settings

DSP MODE MIDNIGHT
1 2 3 4
CH.SELECT
TEST TONE ATT SIG.SELECT
6
5 7 8
CN.LEVEL EFFECT
0 9 0
+10
MEMU
CLASS TV/VCR
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
3
Press % or fi repeatedly to display the name of the
component's manufacturer.
SIGNAL
SELECT
ANALOG
("VCR" is displayed on VSX-D508)
A list of all available preset codes is provided on page 56.
4
Point the remote toward the component to be controlled,
enter the 3 digit setup code.
When you enter the setup code, the remote emits a power ON/OFF
signal. If the component turns ON or OFF, you have entered the proper
code.
If the component does not turn ON or OFF and there is more than one
setup code, press ! or ⁄ to select another code in step 3 or try
inputting another code (starting again from step 2).
Some manufacturers use several sets of remote control signals and the
first code may not correspond to your component.
SIGNAL
SELECT
ANALOG
SIGNAL
SELECT
ANALOG
Repeat steps 2 through 4 to assign preset codes for as many
components as necessary.
5
Press COMMANDER SET UP to exit the preset mode.
The remote control returns to the previous operation mode.
• When operating a PIONEER'S DVD/LD player, set the
memo
• All codes enrolled in the manufacturer code list can be set
• RECEIVER cannot be preset.
Clears all presets and restores factory installed presets.
Press the COMMANDER SET UP and 0 at the same time for
more 3 seconds.
• All the multi-control buttons on the remote control blinks. After
COMMANDER
blinking three times, all the settings are canceled.
SET UP
SP A SIGNAL
SELECT
ANALOG
dB
SIGNAL
SELECT
ANALOG
SP A
SIGNAL
SELECT
ANALOG
dB
SP A
SIGNAL
SELECT
ANALOG
dB
manufacturer code to "000" in the preset mode.
even if a code is not displayed.
Preparations
A
SP SIGNAL
SELECT
ANALOG
dB
SP A
SIGNAL
SELECT
ANALOG
dB
SP A
dB
SP A
dB
23
<ARB7181>
SP A
dB
SP A
dB