Pioneer Elite VSX-21 Operating Instructions Manual page 21

Optical digital input 3 setting
Sets the input component to be assigned to the optical input 3 jack.
• Initial setting is "TV".
memo
• You cannot assign the same component to more than one digital input jack. The jack most
recently selected is established for the component and the jack formerly selected is turned off.
• DVD/LD, TV/SAT, CD, MD/TAPE, VCR 1 digital input connection is possible.
SP
SIGNAL
SELECT
ANALOG
Setting the volume level of each channel (Adjusting the speaker volume balance)
• Sound from the SUB WOOFER seems quiet.
memo
• The speaker volume can be adjusted without outputting the test tone by pressing CHANNEL LEVEL or
CHANNEL SELECT .
• Initial setting is 0 dB.
RECEIVER TV
FQ
+
ENTER
–
FQ
VOL VOL
CHANNEL
MULTI CONTROL
CD
DVD/LD TV/SAT
VCR 1 TUNER
TV CONTROL
VCR 2 MD/TAPE
RECEIVER
DSP MODE MIDNIGHT
1
1 2 4
3
CH.SELECT TEST TONE ATT SIG.SELECT
6
5 7 8
CN.LEVEL EFFECT
4
9
0 +10
MEMU
CLASS TV/VCR
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
A
Press % or fi to set the optical digital input 3 (DVD, TV, CD,
dB
MD, VCR 1).
1
Press
2
Press VOL + or – to adjust the volume to an appropriate
level.
3
Press TEST TONE to output the test tone.
2
The test tone is output in the following order.
3,5
memo
4
Adjust speaker levels so that you hear the test tone at
the same volume from each speaker when seated in the
main listening position.
The channel level ranges ± 10 dB.
memo
5
Press TEST TONE to turn off the test tone.
.
CT
FL
SW SL
• Test tone is only output in Dolby/DTS mode.
• Levels can be set for each surround mode.
Preparations
FR
SR
21
<ARB7181>