Table of Contents
Advertisement
• SIGNAL SELECT is fixed in the "ANALOG" position
for components not assigned to one of the four
digital input jacks.
• Because the audio from a karaoke microphone and
LD recorded with analog audio only is not output
from the digital output, set SIGNAL SELECT to
"ANALOG".
• This receiver can only play back Dolby Digital, PCM
(32kHz, 44kHz, and 48kHz), and DTS digital signal
formats. With digital signal formats other than
these, set SIGNAL SELECT to "ANALOG".
# DSP MODE button
Press repeatedly to select a DSP sound mode (HALL 1,
HALL 2, JAZZ, DANCE, THEATER 1, or THEATER 2).
Use these modes to produce surround sound from
standard (two channel) stereo sources.
$ MIDNIGHT button
Press to hear effective surround sound at low volume
levels. The effect is automatically adjusted according
to the volume level.
% Cinema Re-EQ button
Switches Cinema Re-EQ on or off. Use to high
frequency characteristics are reduced at the front
channels (Front Left, Center, Front Right). (refer to
page 33.)
^ DIGITAL NR button
Switches DIGITAL NR on or off. Use to reduce noise
in digital audio sources (refer to page 34.)
& MASTER VOLUME
After turning on the desired component, rotate to
adjust the volume.
* PHONES jack
Connect headphones for private listening (the
speakers turn off automatically).
( STATION/FREQUENCY (+/–) button
STATION: Press to select the preset channel.
FREQUENCY: Press to select the frequency.
) Function buttons
Selects the function. Each press switches the DVD/LD
input between DVD/LD and DVD 5.1 channel.
_ TAPE 2 MONITOR button
Switches the TAPE 2 monitor on or off (refer to page 42).
+ VIDEO INPUT jacks
Connect a video camera, video game system, etc. to
the VIDEO INPUT jacks (refer to page 10).
Names of Parts and Basic Operations
27
<ARB7181>
Hide quick links:
Advertisement
Table of Contents
