Switching Analog/Digital Signal Input - Pioneer Elite VSX-21 Operating Instructions Manual

Switching ANALOG/DIGITAL Signal Input

The input of the component set in the digital input setting (Refer to page 20, 21) can be switched to an analog or digital
input signal by pressing the SIGNAL SELECT button.
RECEIVER TV
FQ
+
ENTER
–
FQ
VOL VOL
CHANNEL
MULTI CONTROL
CD
DVD/LD TV/SAT
VCR 1 TUNER
TV CONTROL
VCR 2 MD/TAPE
RECEIVER
DSP MODE MIDNIGHT
1 2 4
3
CH.SELECT TEST TONE ATT SIG.SELECT
6
5 7 8
CN.LEVEL EFFECT
9
0 +10
MEMU
CLASS TV/VCR
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
SIGNAL SELECT
1
Press SIG. SELECT on the remote control or SIGNAL
SELECT on the front panel to select the input signal
corresponding to the source component.
Each press switches between ANALOG and DIGITAL signal selection.
SIGNAL
SELECT
ANALOG
SIGNAL
SELECT
DIGITAL
SIG.SELECT
2
While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby
Digital signal is input, and DTS lights when a DTS signal is input
SIGNAL
SELECT
DIGITAL
AC-3
SIGNAL
SELECT
DIGITAL
DTS
memo
• SIGNAL SELECT is fixed in the "ANALOG" position for components not
assigned to one of the four digital input jacks.
• Because the audio from a karaoke microphone and LD recorded with
analog audio only is not output from the digital output, set SIGNAL
SELECT to "ANALOG".
• This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz, and
48kHz), DTS digital signal formats. With digital signal formats other than
these, set SIGNAL SELECT to "ANALOG".
• When an LD or CD player compatible with DTS is played back with
SIGNAL SELECT set in "ANALOG", digital noise is output caused by
playing back the DTS directly (no decoding). To prevent noise, you need to
make digital connections (Refer to pages 20, 21) and set SIGNAL SELECT
to "DIGITAL".
• Some DVD players don't output DTS signals. For more details, refer to the
instruction manual supplied with your DVD player.
SP A
SIGNAL
SELECT
ANALOG
SP A
SIGNAL
SELECT
DIGITAL
SP A
SIGNAL
SELECT
When a Dolby Digital signal is input.
DIGITAL
AC-3
A
SIGNAL SP
SELECT
When a DTS signal is input.
DIGITAL
DTS
Sound Modes
29
<ARB7181>