Table of Contents
Advertisement
Tuner Operations
Automatic and Manual Tuning
The following steps show you how to tune in FM and AM radio broadcasts using the automatic (search) and manual
(step) tuning functions. If you already know the exact frequency of the station you want, see "Direct Tuning" on the
following page.
RECEIVER
TV
FQ
+
3
ENTER
–
FQ
VOL
VOL
CHANNEL
MULTI CONTROL
CD
DVD/LD
TV/SAT
VCR 1
TUNER
TV CONTROL
VCR 2
RECEIVER
MD/TAPE
DSP MODE
MIDNIGHT
1
2
3
4
CH.SELECT
TEST TONE
ATT SIG.SELECT
6
5
7
8
CN.LEVEL
EFFECT
9
0
+10
MEMU
CLASS
TV/VCR
FUNCTION
DIRECT
FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
3
MPX MODE
2
36
<ARB7181>
1
Press FUNCTION repeatedly on the remote or FM/AM on
the front panel to select the tuner. Press TUNER to set
the remote to the tuner operation mode.
2
The station you were previously tuned to is received automatically.
4
SIGNAL
SELECT
ANALOG
1
2
Press ENTER on the remote or FM/AM on the front panel
to select the band (FM or AM).
Each press switches the band: FM j AM
SIGNAL
SELECT
ANALOG
3
Tune in the station.
For Automatic Tuning
Press and hold FQ +/– (%˜fi) for about one second, then release.
The tuner starts searching the selected band and stops automatically at
the first station it locates. Repeat to locate other stations.
For Manual Tuning
• To change frequencies one step at a time, press FQ +/– (%˜fi)
repeatedly.
• To change frequencies quickly, hold down FQ +/– (%˜fi) and release
when you reach the frequency you want.
When using the front panel
Press FREQUENCY (+/–) until the frequency you want appears in the
display.
4
Adjust the volume.
4
MPX Mode
If the TUNED or STEREO indicators do not light when tuning an FM station,
because the station is too far away or the broadcast signal is weak, press
MPX MODE on the front panel to switch to monaural (MONO) reception.
This should improve reception enough for you to enjoy the broadcast.
A
SP
dB
SP
A
SIGNAL
SELECT
j
ANALOG
dB
SP
A
dB
Hide quick links:
Advertisement
Table of Contents
