Adjusting The Remote Control Backlight; Clearing Remote Control Settings - Pioneer VSX-AX5Ai-G Operating Instructions Manual

Using other functions
4 Press the button you want to rename.
5 Edit the button as necessary.
Use (cursor up/down) to select letters and/or
numbers and use (cursor left/right) to move the
cursor forward/back a position. The name can be up to
eight characters (the possible characters are listed
below).
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789 (space)
!"#$%&'()*+,–./:;<=>?@[ \ ]^_`{|}~
| · (space)
6 When you're finished press ENTER.
When you see END flash, press ENTER again.
COMPLETE shows in the display to confirm that the
name has been changed.
• Go back to step 2 to edit more names.
7 When you're finished, use
to select '*Exit*' from the menu and press ENTER.

Adjusting the remote control backlight

You can adjust the brightness of the backlight on the
remote control display, or simply switch it off.
1 Press and hold REMOTE SETUP for three seconds.
The REMOTE SETUP menu appears in the remote control
display.
2 Use (cursor up/down) to select 'Light' from
the menu and press ENTER.
3 Use (cursor up/down) to select 'High', 'Low'
or 'Off' and press ENTER.
COMPLETE appears in the display to confirm the setting.
4 When you're finished, use
to select '*Exit*' from the menu and press ENTER.

Clearing remote control settings

This feature allows you to clear a learned command or
key label for a particular button, or all of the settings from
the remote.
1 Press and hold REMOTE SETUP for three seconds.
The REMOTE SETUP menu appears in the remote control
display.
2 Use (cursor up/down) to select 'Clear' from
the menu and press ENTER.
CLEAR appears in the display.
3 Use (cursor up/down) to select what you
want to clear, and press ENTER.
Choose between the following:
• Learning Clear – Clear a learned command (see
• KeyLabel Clear – Clear a name (see Editing remote
• All Clear – Clear all custom settings you have made
4
component for which you want to clear a command
or key label.
Select Key flashes in the display.
5
The button you selected, then CLEAR? appears in the
display.
6
press ENTER.
(cursor up/down)
COMPLETE appears in the display.
• Select No or *Exit* to exit and return to the REMOTE
7
to select '*Exit*' from the menu and press ENTER.
(cursor up/down)
Programming signals from other remote controls on
page 59) you have assigned to a button (Select
Function flashes in the display).
control display names above) you have assigned to a
button (Select Function flashes in the display).
with the remote (CLEAR? shows in the display). Go to
step 6.
Press the MULTI CONTROL button of the
Press the button you want to clear.
Use (cursor up/down) to select 'Yes' and
SETUP menu.
When you're finished, use
09
(cursor up/down)
69
En