Crossover Network; Fine Channel Level - Pioneer VSX-AX5Ai-G Operating Instructions Manual

Advanced setup

Crossover Network

• Default setting: 80Hz
This setting decides the cutoff between bass sounds
playing back from the speakers selected as LARGE, or
the subwoofer, and bass sounds playing back from those
selected as SMALL. It also decides where the cutoff will
be for bass sounds in the LFE channel.
Note
• For more on selecting the speaker sizes, see Normal
surround setting on page 55.
• You don't need to set the crossover frequency if all
speakers are set to LARGE.
1 Select 'Crossover Network' from the Expert
setup menu.
Expert
[ Crossover Network

[ Fine Channel Level ]

[ Fine Channel Delay ]
[ Acoustic Cal EQ
[ Bass Peak Level
[ D-Range Control
[ Exit
2 Choose the frequency cutoff point.
Frequencies below the cutoff point will be sent to the
subwoofer (or LARGE speakers).
Crossover Network
Frequency [ 50Hz ]
[ 80Hz ]
[ ]
100Hz
[ 150Hz ]
[ 200Hz ]
[ ]
Exit
(THX Speaker = 80Hz)
3 When you're finished, select 'Exit'.
You will return to the Expert setup menu.
]
]
]
]
]
Crossover Network
Frequency [ 50Hz ]
[ 80Hz ]
[ ]
100Hz
[ 150Hz ]
[ 200Hz ]
[ ]
Exit
(THX Speaker = 80Hz)
Fine Channel Level
• Default setting: 0dB (all channels)
You can achieve better surround sound by properly
adjusting the overall balance of your speaker system. The
following setting can help you make detailed
adjustments that you may not achieve using the Normal
surround setting on page 55.
1 Select 'Fine Channel Level' from the Expert setup
menu.
The volume increases to the 0dB reference level.
Caution
• After pressing ENTER, loud test tones will be output.
Expert
[ Crossover Network ]
[ Fine Channel Level ]
[ Fine Channel Delay ]
[ Acoustic Cal EQ ]
[ Bass Peak Level ]
[ D-Range Control ]
[ Exit ]
2 Adjust the level of the left channel.
This will be the reference speaker level, so you may want
to keep the level around 0dB so that you'll have plenty of
room to adjust the other speaker levels.
Fine Channel Level
Left
3 Select each channel in turn and adjust the levels
(+/– 10dB) as necessary.
Use (cursor up/down) to adjust the volume of the
speaker you selected to match the front left (reference)
speaker. When it sounds like both tones are the same
volume, press ENTER to confirm and continue to the next
channel.
Fine Channel Level
STD:Left
Right
Center
Surround
Surround
SurrBack
SurrBack
Subwoofer
[ Exit ]
• If you want to go back and adjust a channel, simply
use (cursor up/down) to select it.
4 When you're finished, select 'Exit'.
You will return to the Expert setup menu.
Fine Channel Level
Please Wait
Caution!!
Test tone is
output loudly.
+
[ ]
10. 0dB
+
10. 0dB
+
[ ]
10. 0dB
+
[ ]
10. 0dB
+
[ ]
L 10. 0dB
+
[ ]
10. 0dB
R
[ + ]
10. 0dB
L
+
[ ]
10. 0dB
R
+
[ ]
10. 0dB
11
87
En