Checking Accessories; Remote Control Unit - Pioneer VSX-D507S Operating Instructions Manual

apeceees
eee aeceee
6
<ARET 166>
\CHECKING ACCESSORIES __
AM loop antenna
FM antenna
aye f
i;
|
L J
Remote control unit Alkaline dry cell batteries
(size "AA" IEC LR6) x 2
Operating instructions
REMOTE CONTROL UNIT _
Loading remote control batteries
2 " AA dry cell batteries (LR6)
/\ CAUTIONS
Incorrect use of batteries may result in
such hazards as leakage and bursting.
Observe the following precautions.
@ Never use new and old batteries together.
@ Insert the plus and minus sides of the batteries prop-
ely according to the marks in the battery conmpartment.
@ Batteries with the same shape may have different
voltages. Do not use different batteries together
Operating range of remote control unit
od
w 2
'
its a
[Memo
7im(23 feet)
Lette w e t
@ The remote control unit may not work if there is an
obstacle between the remote control unit and this unit,
or if the remote control unitis not directed towards the
remote sensor of the main unit at the correct anqle.
@ The remote control unit may not work properly if strong
light such as direct sunlight or fluorescent light is shin-
ing onto the main unit's remote sensor.
® The remote control unit may not work properly when
this unit is used near devices emitting infrared rays, or
when remote control units of other devices which use
infrared rays are used.
On the other hand, the use of this remote control unit
may cause other devices to work improperly.
@ When the operating range of this remote control unit
becomes too short, replace the batteries.
System remote control
Cry falas
{By |
Connect to the CONTROL IN
terminal of other PIONEER
products bearing the &
Remote Control Unit
By connecting a control cord foptional), other PIONEER
products can be operated using this remote control unit,
Point the remote control unit towards the remote sensor
of this unit and operate.
The remote control signals are received by the remote
sensor of this unit, and sent to the other devices via the
CONTROL OUT terminal. By reading other manufactur.
ers' preset codes or memorizing (learning) the remote
control signals of other equipment in this remote control
unit, other manufacturers' equipment can also be oper-
ated using this remote control unit.
When a control cord is connected to the receiver's CON-
TROL IN terminal, direct control of the receiver with the
remote control unit is not possible. Operate the receiver
with the remote controlunit by aiming iat the connected
equipments remote sensor,
7
<ARE7 166>
En
BEF USE