Sacd Setup; Phono/Line Setup - Pioneer VSX-AX5Ai-G Operating Instructions Manual

11 Advanced setup

SACD Setup

• Default setting: OFF
This feature allows you to enjoy the high-quality 1-bit
Direct Stream Digital (DSD) audio from an SACD
directly, bypassing all digital signal processing in the
receiver.
1 Select 'SACD Setup' from the System Setup
menu.
System Setup
[ 1. Surround Setup
[ 2. THX CINEMA Setup ]
[ 3. Input Assign
[ 4. Function Rename
[ 5. SACD Setup

[ 6. PHONO/LINE Setup ]

[ 7. Multi Room
[ 8. 12V Trigger
[ Exit
2 Select 'SACD DIRECT' and set it ON or OFF.
• ON – Listen to SACD sources with no digital signal
processing
• OFF – Digital signal processing will be applied to
SACD sources
Tip
• To avoid an interruption in the audio you can use the
remote to switch the SACD Direct feature on or off.
After pressing RECEIVER, press EFFECT/CH SEL to
select DIRECT and then use the +/– buttons to adjust
the setting.
• When the SACD Direct feature is switched on, the
center and subwoofer channels of a multichannel
SACD disc will be downmixed to the front left and
right channels.
3 When you're finished, select 'Exit'.
You will return to the System Setup menu.
Note
• When you're playing an SACD over an i.LINK
connection and SACD DIRECT has been switched
on, the speaker setting (page 55) and speaker
distance (page 57) settings will not be applied.
84
En
5. SACD Setup
] SACD DIRECT
[ Exit ]
]
]
]
]
]
]
5. SACD Setup
SACD DIRECT [ ON ]
[ Exit ]
PHONO/LINE Setup
• Default setting: PHONO
You can choose whether you want to use the PHONO
jack on the rear of the receiver to connect a turntable, or
a line level component (such as a CD or DVD player).
1 Select 'PHONO/LINE Setup' from the System
Setup menu.
The current setting is highlighted in the display.
System Setup
[ OFF ] [ 1. Surround Setup
[ 2. THX CINEMA Setup ]
[ 3. Input Assign
[ 4. Function Rename
[ 5. SACD Setup
[ 6. PHONO/LINE Setup
[ 7. Multi Room
[ 8. 12V Trigger
[ Exit ]
2 Select either PHONO or LINE.
• PHONO – High level setting for turntables (without a
built-in equalizer or pre-amplifier)
• LINE – Line level setting for all audio components
other than a turntable (except those with a built-in
phono equalizer
3 When you're finished, select 'Exit'.
You will return to the System Setup menu.
6. PHONO / LINE Setup
] [ PHONO ]
[ LINE ]
] [ Exit ]
]
]
]
]
]