11
Advanced setup
Chapter 11
Advanced setup
The System Setup menu
The System Setup menu is where you can make
customized settings to reflect how you are using the
receiver.
1
Switch on the receiver and your TV.
2
Using the remote control, press RECEIVER, then
press the SYSTEM SETUP button.
An on-screen display (OSD) appears on your TV. Use the
(cursor up/down) buttons and ENTER on the remote
control to navigate through the screens and select menu
items.
Tip
• You can also use the front panel display to make
settings. You can also use the MULTI JOG dial and
ENTER on the front panel instead of the
up/down) buttons and ENTER on the remote control.
3
Select the setting you want to adjust then press
ENTER.
80
En
RECEIVER
RECEIVER
SYSTEM SETUP
ENTER
System Setup
[
1. Surround Setup
]
[ 2. THX CINEMA Setup ]
[ 3. Input Assign
]
[ 4. Function Rename
]
[ 5. SACD Setup
]
[ 6. PHONO/LINE Setup ]
[ 7. Multi Room
]
[ 8. 12V Trigger
]
[ Exit
]
• Surround Setup – Access the setup menu for basic
surround sound settings (see Making receiver
settings from the Surround Setup menu on page 54
for more on this).
• THX CINEMA Setup – Select the decoding method
used with the THX CINEMA mode (see THX CINEMA
Setup below).
• Input Assign – Specify what you've connected to the
digital, component video and i.LINK inputs (see The
Input Assign menu below).
• Function Rename – Change the names that appear
on the receiver display and on-screen display (see
Function Rename on page 83).
• SACD Setup – Bypass the signal processing of this
receiver to hear 1-bit Direct Stream Digital (DSD)
audio from an SACD directly (see SACD Setup on
page 84).
• PHONO/LINE Setup – Specify how you're using the
PHONO jack on the rear of the receiver (see PHONO/
LINE Setup on page 84).
• Multi Room – Specify your volume setting for a
multi-room setup and your IR receiver type (see Multi-
Room and IR receiver setup on page 85).
• 12V Trigger – Specify which components are
switched on or off using the 12 volt trigger (see 12 Volt
Trigger on page 85).
4
Make the adjustments necessary for each
setting, pressing ENTER to confirm after each
setting.
(cursor