Main Menu For Route Planning; How To Create A New Route - Furuno FMD-3200 Operator's Manual

9. ROUTES
9.2

Main Menu for Route Planning

The main parameters for the route planning are:
• Latitude and longitude of the waypoint
• Channel limits to the waypoint
• Turning radius of the waypoint
• Maximum speed limit and planned speed for each leg
There are two phases for a route: Route Plan and Route Monitor. Route plan is used
for planning the route and route monitor is used to control a route for monitoring.
To complete route planning, do the following.
1. Create a new route or choose an existing one. See section 9.3.
2. Modify your route if necessary. See section 9.4.
3. Make chart alert (safe water) calculation. See section 9.3.5.
4. Optimize your route. See section 9.7.
9.3

How to Create a New Route

To make a complete route for a voyage, do the following:
1. Click the [PLAN] button on the Status bar to activate the Voyage planning mode.
2. On the InstantAccess bar, click the [Planning] button followed by the [Route] but-
ton to open the [Route Plan] dialog box.
3. Click the [New] button.
4. Use the cursor to select a position for the first waypoint then push the left mouse
button. A waypoint mark appears on the position selected, and the latitude and
longitude of the position, etc. are entered into the [Route Plan] dialog box. After
entering a waypoint, edit Name, Steering mode, Radius, Channel limit, Plan SPD,
SPD Max and Margin as appropriate in the [Route Plan] dialog box, using the key-
board on the Control Unit or software keyboard.
To change the settings of items other than L/L position: Put the cursor on an
item to show up and down arrows then click required arrow.
To change L/L position: Put the cursor on the digit to change and roll the scroll-
wheel.
9-2