Pioneer PDP-501MX Technical Manual page 53

THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
4) Adjusting the angle
This mounting hardware can be tilted 25 degrees, without set increments. This work should be done by two people.
1 Loosen screw c on the left and right vertical frames.
2 While sliding the arm down, push the display to the desired angle.
3 Once the desired angle is reached, tighten screw c on the left and right frames.
After mounting the unit at an angle, an additional
reinforcement measure can be taken by attaching an
appropriate wire flat bar using screws (a).
THIS ITEM IS NOT AVAILABLE. PLEASE CONTACT PIONEER FOR INFORMATION
c
When mounting the display flush or parallel to the wall,
secure the movable and fixed portions of the mount frame
by tightening the screws a, as shown. This prevents
accidental tilting of the display. You must also tighten the
left and right c screws.
Measuring the opening distance x enables approximate
angle values to be determined.
X
181mm
236mm
290mm
341mm
a
Angle
5˚
10˚
15˚
20˚
53