Toyota Lexusc Owner's Handbook Manual page 144

(b) Operating the HomeLink
R
To operate the HomeLink , press the appropriate HomeLink
button to activate the programmed device. The HomeLink
indicator light should come on. The HomeLink
send the signal for up to 20 seconds as long as the button is
pressed.
(c) Erasing the entire HomeLink
three programs)
To erase all previously programmed codes at one time, press
and hold down the 2 outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase the programs stored
R
in the HomeLink memory.
R
R
R
R
continues to
R
memory (all
INTERIOR EQUIPMENT
CAUTION
D When programming the HomeLink
Transceiver, you may be operating a garage door or
other device. Make sure people and objects are out
of the way of the garage door or other device to
prevent potential harm or damage.
R
D Do not use this HomeLink
with any garage door opener that lacks the safety
stop and reverse feature as required by federal safety
standards. (This includes any garage door opener
model manufactured before April 1, 1982.) A garage
door opener which cannot detect an object (signaling
the door to stop and reverse), does not meet current
federal safety standards.
opener without these features increases risk of
serious injury or death.
R
Universal
Universal Transceiver
Using a garage door
125