Setting The Type Of Amplifier To Be Connected (Digital Jack) - Pioneer PDV-10 Operating Instructions Manual

Setting the type of amplifier to be connected (digital jack)

Here set the type of digital signal the amplifier connected to the player's digital
output jack is compatible with.
Main unit
Remote control unit
ENTER
Cursor
buttons
Making Settings with the Setup Navigator
ENTER
Cursor
buttons
4 ¢
1 3 ¡
e 8 E 7
Use the cursor buttons (5/∞) to
select the digital signal with
which the amplifier is compatible,
then press the ENTER button.
Audio1 2 Video Language
Setup Navigator
Dolby Digital
Dolby Digital/DTS
Dolby Digital/MPEG
Amp Connection
Digital Jacks
i Compatible with Dolby Digital
Move Select
ENTER
• Dolby Digital: Select this when the amplifier
or decoder connected to the player is
compatible with Dolby Digital signals.
• Dolby Digital/DTS: Select this when the
amplifier or decoder connected to the player is
compatible with Dolby Digital and DTS signals.
• Dolby Digital/MPEG: Select this when the
amplifier or decoder connected to the player is
compatible with Dolby Digital and MPEG
signals.
• Dolby D/DTS/MPEG: Select this when the
amplifier or decoder connected to the player is
compatible with Dolby Digital, DTS and MPEG
signals.
• PCM: Select this when the amplifier
connected to the player is a stereo amplifier or
a Dolby Pro-Logic compatible amplifier.
• Not connected: Select this when no amplifier
is connected or when you do not know the
type of the connected amplifier. When this is
selected, there is no need to make the
"Amplifier's 96 kHz Compatibility" setting, so
proceed to "Quitting the Setup Navigator"
(page 47).
General Other
Dolby D/DTS/MPEG
PCM
Not Connected
Exit
SETUP
45
En