Troubleshooting - Pioneer PDV-10 Operating Instructions Manual

Troubleshooting

If the problem persists after checking
the points below, contact your store of
purchase.
Power does not turn on
\ Connect the AC adapter properly.
(Page 41)
Playback is not possible
\ Disc is extremely dirty.
\ Disc is not properly set on disc table.
\ Region number is wrong.
\ There is condensation inside the player.
\ SECAM format discs cannot be played
on this player.
\ Disc is loaded upside-down.
\ Audio/video input/output selector
switch is set to AV-IN (left side).
\ When the TV SYSTEM switch is set
to NTSC or AUTO, the display screen
is turned off and the video image is
not displayed.
mark appears on screen
\ The operation is prohibited by the disc itself.
mark appears on screen
\ The operation is prohibited by the player.
Picture stops or buttons do not operate
\ Press the pause button, then resume playback.
\ Main unit's power switch is set to "HOLD".
Settings are cleared
\ The settings are cleared if there is a power
failure or the power cord is unplugged
while the power is on. Before unplugging
the power, always slide the main unit's
power switch or press the power button
on the remote control unit so that "OFF"
turns off on the main unit's display
window.
" " appears during setup operation
\ A setting that can only be set for DVDs has
been selected while a CD or video CD is loaded.
Picture is stretched or aspect is
wrong
\ TV size setting is wrong.
Picture is disturbed or dark when
playing a DVD
\ This player is compatible with analog
copy protect type copy guards. Some
discs include copy prohibit signals.
Problems such as horizontal stripes
on the picture, etc., may occur when
such discs are played. This is not a
malfunction of the player.
Playback stops or power turns off
during operation
\ When using the battery pack
(PDV-BT10), to save energy the stop
mode is set after about 5 minutes in
the pause mode and the power is
turned off about 5 minutes after the
stop mode is set.
119
En