Displaying And Maintaining Habp; Habp Configuration Example - HP 3600 v2 Series Security Configuration Manual

To do...
Configure HABP to work in client
mode
Specify the VLAN to which the
HABP client belongs
NOTE:
The VLAN to which an HABP client belongs must be the same as that specified on the HABP server for
transmitting HABP packets.

Displaying and maintaining HABP

To do...
Display HABP configuration
information
Display HABP MAC address
table entries
Display HABP packet statistics

HABP configuration example

Network requirements
As shown in
authentication is configured on Switch A for central authentication and management of users (Host A
through Host D).
For communication between Switch B and Switch C, enable HABP server on Switch A, enable HABP
client on Switch B and Switch C, and specify VLAN 1 for HABP packets.
Configure the HABP server to send HABP request packets to the HABP clients in VLAN 1 at an interval of
50 seconds.
Use the command...
undo habp server
habp client vlan vlan-id
Use the command...
display habp [ | { begin |
exclude | include }
regular-expression
display habp table [ | { begin |
exclude | include }
regular-expression
display habp traffic [ | { begin
| exclude | include }
regular-expression
Figure 91, Switch A is attached with access devices Switch B and Switch C. 802.1X
]
]
]
227
Remarks
Optional
HABP works in client mode by
default.
Optional
By default, an HABP client belongs
to VLAN 1.
Remarks
Available in any view
Available in any view
Available in any view