Configuring Triple Authentication; Triple Authentication Configuration Examples; Triple Authentication Basic Function Configuration Example - HP 3600 v2 Series Security Configuration Manual

Configuring triple authentication

Follow these steps to configure triple authentication:
To do...
Configure 802.1X authentication
Configure MAC authentication
Configure Layer-2 portal authentication
NOTE:
802.1X authentication must use MAC-based access control.
•
HP does not recommend you configure 802.1X guest VLANs for triple authentication.
•

Triple authentication configuration examples

Triple authentication basic function configuration example

Network requirements
As shown in
authentication on the Layer-2 interface of the switch that connects to the terminals so that a terminal
passing one of the three authentication methods, 802.1X authentication, portal authentication, and MAC
authentication, can access the IP network.
Configure static IP addresses in network 192.168.1.0/24 for the terminals.
•
• Use the remote RADIUS server to perform authentication, authorization, and accounting and
configure the switch to send usernames carrying no ISP domain names to the RADIUS server.
The local portal authentication server on the switch uses listening IP address 4.4.4.4. The switch
•
sends a default authentication page to the web user and forwards authentication data using HTTP.
Figure 86 Network diagram
Configuration procedure
Figure 86, the terminals are connected to a switch to access the IP network. Configure triple
Use the command...
See the chapter "802.1X
configuration"
See the chapter "MAC authentication
configuration"
See the chapter "Portal configuration"
192
Remarks
Required
Configure at least one
type of authentication.