Vlan Configuration - KTI Networks KGS-1064-HP User Manual

Fast Leave
Throttling
Save
Reset

2.10.2.2 VLAN Configuration

Each page shows up to 99 entries from the VLAN table, default being 20, selected through the "entries per
page" input field. When first visited, the web page will show the first 20 entries from the beginning of the
VLAN Table. The first displayed will be the one with the lowest VLAN ID found in the VLAN Table.
Configuration
Delete
VLAN ID
MLD Snooping Enabled
MLD Querier
Compatibility
RV
QI
QRI
If an aggregation member port is selected as a router port, the whole aggregation will
act as a router port.
Enable the fast leave on the port.
Enable to limit the number of multicast groups to which a switch port can belong.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
Description (Example with MSTI1)
Check to delete the entry. The designated entry will be deleted during the next save.
The VLAN ID of the entry.
Enable the per-VLAN MLD Snooping. Up to 32 VLANs can be selected for MLD
Snooping.
Enable the MLD Querier in the VLAN.
Compatibility is maintained by hosts and routers taking appropriate actions
depending on the versions of MLD operating on hosts and routers within a network.
The allowed selection is MLD-Auto, Forced MLDv1, Forced MLDv2, default
compatibility value is MLD-Auto.
Robustness Variable. The Robustness Variable allows tuning for the expected packet
loss on a network. The allowed range is 1 to 255, default robustness variable value is
2.
Query Interval. The Query Interval is the interval between General Queries sent by
the Querier. The allowed range is 1 to 31744 seconds, default query interval is 125
seconds.
Query Response Interval. The Maximum Response Delay used to calculate the
-98-