KTI Networks KGS-1064-HP User Manual page 119

Port VLAN ID (PVID)
Tx Tag
Refresh
Save
Reset
None - a VLAN tag with the classified VLAN ID is inserted in frames transmitted on
the port. This mode is normally used for ports connected to VLAN aware switches.
Tx tag should be set to Untag_pvid when this mode is used.
Specific (the default value) - a Port VLAN ID can be configured (see below).
Untagged frames received on the port are classified to the Port VLAN ID. If VLAN
awareness is disabled, all frames received on the port are classified to the Port VLAN
ID. If the classified VLAN ID of a frame transmitted on the port is different from the
Port VLAN ID, a VLAN tag with the classified VLAN ID is inserted in the frame.
Configures the VLAN identifier for the port. The setting is abbreviated as PVID. The
allowed values are from 1 through 4095. The default value is 1.
Note: The port must be a member of the same VLAN as the Port VLAN ID.
Determines egress tagging of a port.
Untag_pvid - All frames except the configured PVID will be tagged. The frames that
the associated classified VID match egress port's PVID are NOT inserted with any
tag. All other frames are with the associated classified tag in egress.
Tag_all - All frames are tagged. All frames are inserted with the associated classified
tag in egress.
Untag_all - All frames are untagged. All frames are NOT inserted with the associated
classified tag in egress.
Note:
1. The value of TPID (Ethertype) for the inserted tag determined by the egress port
type as follows:
Unaware
C-port
S-port
S-custom-port
2. The inserted tag is inserted at the outer tag position in a frame.
Click to refresh the page; any changes made locally will be undone.
Click to save the changes.
Click to undo any changes made locally and revert to previously saved values.
C-tag (0x8100)
C-tag (0x8100)
S-tag (0x88A8)
The setting of Ethertype for Customer S-port
-119-