KTI Networks KGS-1064-HP User Manual page 177

Rx Packets Dropped
Tx Requests
Tx Retransmissions
Tx Pending Requests
Tx Timeouts
IP Address
State
Round-Trip Time
server on the accounting port.
RFC4670 name: radiusAccClientExtPacketsDropped
The number of RADIUS packets that were received from the server on the
accounting port and dropped for some other reason.
RFC4670 name: radiusAccClientExtRequests
The number of RADIUS packets sent to the server. This does not include
retransmissions.
RFC4670 name: radiusAccClientExtRetransmissions
The number of RADIUS packets retransmitted to the RADIUS accounting server.
RFC4670 name: radiusAccClientExtPendingRequests
The number of RADIUS packets destined for the server that have not yet timed out or
received a response. This variable is incremented when a Request is sent and
decremented due to receipt of a Response, timeout, or retransmission.
RFC4670 name: radiusAccClientExtTimeouts
The number of accounting timeouts to the server
After a timeout, the client may retry to the same server, send to a different server, or
give up. A retry to the same server is counted as a retransmit as well as a timeout. A
send to a different server is counted as a Request as well as a timeout.
The IP address of the selected server
Shows the state of the server. It takes one of the following values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP communication is not yet up and running.
Ready: The server is enabled, IP communication is up and running, and the RADIUS
module is ready to accept accounting attempts.
Dead (X seconds left): Accounting attempts were made to this server, but it did not
reply within the configured timeout. The server has temporarily been disabled, but
will get re-enabled when the dead-time expires. The number of seconds left before
this occurs is displayed in parentheses. This state is only reachable when more than
one server is enabled.
radiusAccClientExtRoundTripTime
The time interval (measured in milliseconds) between the most recent Response and
the Request that matched it from the RADIUS accounting server
The granularity of this measurement is 100 ms. A value of 0 ms indicates that there
hasn't been round-trip communication with the server yet.
-177-