KTI Networks KGS-1064-HP User Manual page 90

Delete
MVR VID
MVR Name
Mode
Tagging
Priority
LLQI
Interface Channel Setting
Port
Port Role
the MVR group table is full.
Check to delete the entry. The designated entry will be deleted during the next save.
Specify the Multicast VLAN ID.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports.
MVR Name is an optional attribute to indicate the name of the specific MVR VLAN.
Maximum length of the MVR VLAN Name string is 32. MVR VLAN Name can
only contain alphabets or numbers. When the optional MVR VLAN name is given, it
should contain at least one alphabet. MVR VLAN name can be edited for the existing
MVR VLAN entries or it can be added to the new entries.
Specify the MVR mode of operation. In Dynamic mode, MVR allows dynamic MVR
membership reports on source ports. In Compatible mode, MVR membership reports
are forbidden on source ports. The default is Dynamic mode.
Specify whether the traversed IGMP/MLD control frames will be sent as Untagged
or Tagged with MVR VID. The default is Tagged.
Specify how the traversed IGMP/MLD control frames will be sent in prioritized
manner. The default Priority is 0.
Define the maximum time to wait for IGMP/MLD report memberships on a receiver
port before removing the port from multicast group membership. The value is in units
of tenths of a second. The range is from 0 to 31744. The default LLQI is 5 tenths or
one-half second.
When the MVR VLAN is created, click the Edit symbol to expand the corresponding
multicast channel settings for the specific MVR VLAN. Summary about the Interface
Channel Setting (of the MVR VLAN) will be shown besides the Edit symbol.
The logical port for the settings
Configure an MVR port of the designated MVR VLAN as one of the following roles.
Inactive: The designated port does not participate MVR operations.
Source: Configure uplink ports that receive and send multicast data as source ports.
Subscribers cannot be directly connected to source ports.
Receiver: Configure a port as a receiver port if it is a subscriber port and should only
receive multicast data. It does not receive data unless it becomes a member of the
multicast group by issuing IGMP/MLD messages.
Be Caution: MVR source ports are not recommended to be overlapped with
management VLAN ports.
Select the port role by clicking the Role symbol to switch the setting.
I: indicates Inactive; S: indicates Source; R indicates Receiver
-90-