3.3.10 Removing the spindle motor board
(See Figs.13 and 14)
• Remove the DVD servo board.
• Remove the clamper base.
• Remove the DVD traverse mechanism assembly.
(1) From the top side of the DVD traverse mechanism assem-
bly, remove the feed motor wire that is soldered to the spin-
dle motor board. (See Fig.13.)
(2) From the bottom side of the DVD traverse mechanism as-
sembly, remove the three screws G attaching the spindle
motor board. (See Fig.14.)
Spindle motor board
DVD traverse mechanism assembly
Fig.13
G
DVD traverse mechanism assembly
Fig.14
Remove the solders.
Feed motor
wire
G
(No.22023)1-19