JVC RX-DV31SL Service Manual page 13

Home theater dvd-audio/video receiver

Hide thumbs Also See for RX-DV31SL:

Enlarged version

3.2

Front panel assembly section

3.2.1 Removing the FL board

(See Figs.21 and 22)

• Prior to performing the following procedures, remove the top

cover and front panel assembly.

(1) From the front side of the front panel assembly, pull out the

volume knob assembly in the direction of the arrow. (See

Fig.21.)

(2) From the back side of the front panel assembly, remove the

eight screws X attaching the FL board. (See Fig.22.)

(3) Disconnect the wire from the connector CN703 on the FL

board while lifting the FL board slightly. (See Fig.22.)

(4) Remove the solders from the soldered points f and g at-

taching the parallel wires while lifting the FL board. (See

Fig.22.)

(5) Take out the FL board from the front panel assembly.

Reference:

Remove the parallel wires as required.

Fig.21

Front panel

FL board

Soldered point f

Fig.22

Front panel

assembly

Volume knob assembly

Soldered point g

CN703

Wire

(No.22023)1-13

Table of Contents