Skoda Rapid Operating Instructions Manual page 51

Connection using Wi-Fi direct to SmartGate

Read and observe and
This type of connection is provided for communication devices and applica-
tions that support connection via Wi-Fi Direct.
Connection set-up
›
Switch on the ignition.
›
In the device to be connected start the ŠKODA application that supports con-
nection via Wi-Fi Direct.
›
In the application, select the connection function (e.g. "Connect"), this starts
to search for available devices that support Wi-Fi Direct.
›
In the menu of the detected networks select from the menu "SmartGate_..."
›
Enter the PIN code (the factory default setting for the password is the last
six digits of the vehicle identification number).
If you want to connect to SmartGate from another vehicle, then after the start
of the application, disconnect the previous connection by selecting the separa-
tion function (e.g. "Disconnect ").
Disconnection
The connection can be switched off in one of the following ways.
›
In the application, the separation function (e.g. "Disconnect") is selected.
›
By turning off the Wi-Fi Direct in the connected device.
›
By switching off the ignition for more than 5 s (for vehicles with starter but-
ton - by turning off the engine and opening the driver's door).
Automatic connection
If the communication device once had a connection with SmartGate, then the
connection is automatically restored after the start of the application.
SmartGate web interface

Read and observe and
In the SmartGate Web interface it is possible to set-up SmartGate and the Wi-
Fi connection to SmartGate.
The following address must be entered via Wi Fi in the web browser of the
connected device.
1)
The last six symbols of the VIN vehicle identification number of your vehicle are displayed at position ....
48
Using the system
on page 47 first.
on page 47 first.
HTTP://192.168.123.1
The setting changes are only noticeable after pressing the buttons "Save" and
"Reboot".
.
1)