Rear Light
Fig. 179 Remove light / pull out connector
Read and observe
and
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel covers
kit into opening
» Fig.
179.
A
›
Remove the cover by pulling the hook in the direction of arrow
›
Unscrew the screws
with the key from the tool kit.
B
›
Grasp the lamp and carefully remove in the direction of arrow
›
Press the latch on the connector in the direction of arrow
›
Carefully remove the connector from the tail lamp assembly in the direction
of the arrow
.
4
Fitting
›
Insert the bulb holder into the lamp.
The lock on the plug must be inserted securely.
›
Insert the lamp with the pin
B
» Fig. 179
in the body.
174
Do-it-yourself
on page 170 first.
» page
153, Vehicle tool
2
.
3
» Fig. 180
on page 174 into the recesses
›
Carefully push the cover in
›
Screw the lamp into place and install the cover.
The cover must engage securely.
CAUTION
Ensure that the cable bundle does not become pinched between the body
■
and the lamp when it is being refitted – risk of damage to the electrical instal-
lation and risk of water ingress.
If you are not sure whether the cable bundle has become pinched, we recom-
■
mend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing bulbs in rear light
Fig. 180 Outer part of the lamp/inner part of the lamp
Read and observe
Outer part of the lamp
.
1
›
Rotate the lamp socket
direction of arrow
.
›
Changing the lamp, reinsert the holder with the bulb into the lamp housing
and turn in the opposite direction of the arrow
Inner parts of the lamp
›
Unlock the bulb holder using the marked area with arrows
move the bulb holder from the light.
›
Turn the respective bulb counter clockwise until it stops.
›
Remove the holder from the lamp.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
C
stop.
»
.
and
on page 170 first.
» Fig. 180
in direction of arrow
A
from the lamp housing.
2
to the stop.
1
and remove in
1
» Fig. 180
and re-