12
6
Check the horizontal position of the punched holes.
–
To increase width A, touch [+] to increase the adjustment (between -5.0 and +5.0).
–
Each time [+] or [-] is touched, the value is increased or decreased by one increment.
–
To decrease width A, touch [-] to decrease the adjustment (between -5.0 and +5.0).
7
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completes
the procedure.
8
Use a Punch setting to print another sample copy.
9
Check the print result.
–
Check that the horizontal position of the punched holes was adjusted.
–
If more adjustment is necessary, repeat steps 6 through 9.
12-50
Utility mode
bizhub 501/421/361 (Version 2)