Charging The Battery (Series B); Charger Indicator Lights - Graco 24N950 Operation - Repair - Parts

Charging the Battery (Series B)

Battery charger is for indoor use only. Do not expose
charger to rain or snow. Charge battery with
Graco-approved charger.
NOTE: Fully charge battery prior to first use.
1. Place field marker in a dry, well-ventilated area
away from flammable or combustible materials,
including paints and solvents.
2. Before charging, make sure spray button (A) is out
(OFF position).
A
3. Plug charger into an electrical outlet.

Charger Indicator Lights

Power on with no battery connected
Desulfating
Charging
Charged/Float charging
Reverse polarity
Sleep mode. If the battery is fully charged or the charged is
connected to a fully charged battery the charger may go into
the sleep mode.
NOTE: Disconnect charger from field marker after battery is fully charged. Charge times will vary from 0 - 14 hours
depending on level of discharge.
332119E
ti20194a
ti2810a
Description
4. Plug 12V charger jack into battery connection port
on field marker.
ti24686a
5. When charging is complete, disconnect charger
from electrical outlet. Then disconnect charger from
battery connection port on field marker.
Appearance
Power LED is red
First charging light is green and stays on until the bulk
charge cycle starts.
Charging lights lite to indicate show the state of
charge.
All four charging lights are on solid.
All four charging lights flash.
All four charging lights dim and flash.
Charging the Battery (Series B)
ti7949a
9