Starting A New Job - Graco 24N950 Operation - Repair - Parts

Starting a New Job

1. Perform Pressure Relief Procedure, page 10.
ti20183a
If material fails to flow through prime hose, the inlet ball
check valve may be stuck due to improper cleaning and
storage. Reach into hopper. Press button to break the inlet
ball check free.
ti24707a
2. Pour material into paint hopper (S).
3. Prime the Pump:
332119E
NOTICE
S
ti20214a
a. To fill field marker with fluid, press spray button
(A) and allow field marker to run until material
flows through prime hose.
A
ti20212a
b. Stop field marker by pressing spray button.
4. Put prime/spray valve (D) in DOWN position.
ti20184a
5. Reverse spray tip (X) to UNCLOG position, spray
for two seconds and then stop.
NOTE: Failure to perform this operation could result
in poor spray pattern.
X
6. Put prime/spray valve (D) UP to release pressure.
Then rotate spray tip (X) back to spray position.
D
ti20183a
7. Put prime/spray valve (D) down and you are ready
to spray.
ti20184a
Starting a New Job
ti21316a
D
ti20192a
X
ti20191a
D
ti20213a
13