Repair
Control Board Replacement
Removal
1. Disconnect battery wires. See Battery
Removal steps 1 - 5, page 22.
2. Disconnect two wires from battery charger connec-
tion port.
3. Remove six torx screws from board. Remove board
from battery shroud.
ti21370a
24
Installation
1. Install new board into battery shroud. Tighten six
torx screws into board.
2. Connect negative wire (black) to outer connector of
charger jack. Connect positive wire (red) to inner
connector of charger jack.
3. Connect battery wires. See Battery
ti24688a
Installation steps 2 - 5, page 23.
ti24688a
332119E