Starting a New Job
Adjusting Line Width
With Shields
1.
Perform Pressure Relief Procedure, page 10.
ti20183a
2. Remove height adjustment mount (J) and material
dispenser arm assembly.
J
ti21320a
3. Install inner spray shield assembly (M) by collapsing
spring and sliding shield onto horizontal D-bar.
M
4. Install height adjustment mount (J) and material dis-
penser arm assembly
ti21321a
14
ti21319a
J
5. Install outer spray shield assembly (M) by collapsing
spring and sliding shield onto horizontal D-bar.
ti20187a
6. Adjust shields to the desired line width. Spray tip
should be centered between shields. Spray pattern
should touch shields just above the bottom of the
shields.
ti20187a
Without Shields
1.
Perform Pressure Relief Procedure, page 10.
2. Move vertical material dispenser bar holder to
outside position.
3. Adjust height of tip to adjust line width (raising tip
height will create wider lines).
NOTE: Different tip sizes are available for lines
greater than 6 in. (15 cm) wide. Use Graco part
number LL5417 for wider lines.
M
ti20189a
332119E