Fuse Replacement - Graco 24N950 Operation - Repair - Parts

Fuse Replacement

Removal
1. Perform Pressure Relief Procedure, page 10.
ti20183a
2. Disconnect motor plug and spray button plug.
Motor Plug
3. Remove material dispenser (E) and paint hopper (S).
E
ti21485a
4. Use wrench to remove two bolts and remove battery
shroud (B).
ti21369a
5. Open fuse case and remove old fuse.
30 AMP
Automotive
Regulator ATO
ti21364a
332119E
ti21362a
Spray Button Plug
S
ti21363a
B
Installation
1. Insert a new standard 30 A automotive fuse (Regu-
lar ATO) fuse into fuse case.
2. Place front tabs of battery shroud into slots, then
pivot back of shroud down. Use wrench to tighten
two bolts and secure shroud into place.
ti21368a
When installing the battery shroud, wires can get
pinched between the shroud and frame and become
damaged. To avoid damage, make sure all wires are
kept in front of the battery when installing the shroud.
3. Install paint hopper (S) and material dispenser (E).
S
ti21486a
4. Connect spray button plug and motor plug.
Motor Plug
NOTICE
E
ti21487a
Spray Button Plug
Repair
ti21362a
21