Cisco Nexus 7702 Hardware Installation Manual page 72

Installing or Replacing an I/O Module
• Verify that the chassis is grounded (see
• Verify that you have the following tools and equipment:
Step 1 Open a slot in the chassis for the new I/O module as follows:
Note If you need to remove a blank filler plate from the slot, unscrew the captive screws on either side of the module
and pull the handle on the plate to remove it from the slot. Continue with Step 2.
a) Disconnect all of the networking cables attached to the front of the I/O module to be removed.
b) Unscrew the captive screw on each side of the module until the screws are loose and no longer connected to the
chassis (see Callout 1 in the following figure).
Figure 17: Removing an I/O Module
1 Loosen the two captive screws
2 Press the two ejector buttons
c) Press the two ejector buttons on the each side of the module (see Callout 2 in the above figure).
The two handles spring out part way from the front of the module.
d) Fully rotate the two handles away from the front of the module and pull on them to move the module part way out
of its slot.
Cisco Nexus 7702 Hardware Installation Guide
62
◦ Whenever a module is outside a grounded chassis, place it flat on an antistatic surface or in an
antistatic bag. Never lean the module on anything nor place anything else on top of the module
nor lean anything on the module.
◦ Number 1 Phillips torque screwdriver
Manual torque screwdrivers are recommended. Be sure to never exceed the recommended
Note
torque setting for the screw that you are working with.
◦ Replacement or new I/O module
Installing or Replacing Modules, Fan Trays, and Power Supplies
Grounding a Switch Chassis, on page
3 Two handles spring out part way from the front of
the module
23).