Cisco Nexus 7702 Hardware Installation Manual page 28

Installing the Chassis in a Two-Post Rack
Step 4
Push the chassis all the way onto the rack so that the vertical mounting brackets on the chassis come in contact with the
vertical mounting rails on the rack.
Step 5 Use 2 center mount-brackets with eight M4 screws and two M3 screws to attach each of the two vertical mounting
brackets on the chassis to the two vertical mounting rails on the rack. It is recommended to use a minimum of 8 screws
(user preference from the accessory kit) on the front of the chassis to secure the chassis to the 2-post rack.
Figure 5: Attaching the Chassis to the Rack
1
2
Step 6 If you removed the fan tray before moving the chassis, reinstall each one in the chassis as follows:
a) Holding each of the two handles on the fan tray with your two hands, align the fan tray to an open fan tray slot.
b) Slide the fan tray into the slot until the front of the fan tray comes in contact with the rear of the chassis.
The two alignment pins on the fan tray (on the left and the right) should go into holes in the chassis and the
Note
two captive screws on the fan tray should align to screw holes in the chassis.
Cisco Nexus 7702 Hardware Installation Guide
18
Vertical mounting rails on the rack
Install a total of eight screws (user preference from the accessory kit) at the front to secure the chassis.
Installing the Switch Chassis