Cisco Nexus 7702 Hardware Installation Manual page 70

Installing or Replacing a Supervisor Module
b) Press the ejector button next to the handle to release the handle from the front of the module (see Callout 1 in the
following figure).
Figure 15: Positioning a Half-Width Supervisor Module to its Slot
1 Rotate the handle fully away from the front of the
module.
2 Align the bottom of the module to the module guides
in the slot.
c) Rotate the end of the handle away from the front of the module until it stops (see Callout 1 in the previous figure).
d) With one hand under the supervisor module and the other hand holding the module by its front, align the rear of the
module to the open supervisor slot.
e) Slide the module onto the guides inside the slot and push the module fully into the slot until you cannot push the
module further.
The front of the module should be about 1/4 inch (0.6 cm) in front of the chassis.
f) Rotate the handle to the front of the module (see Callout 1 in the following figure) until it clicks when it reaches the
front of the module.
Cisco Nexus 7702 Hardware Installation Guide
60
Installing or Replacing Modules, Fan Trays, and Power Supplies
3 Push the module all the way into the slot (until it
stops and the front is about 1/4 inch in front of the
chassis).