Sd Led-Sd Card Status; Related Commands; Show Led - Cisco 1120 Hardware Installation

Figure 2 SD Card LED (Item 1)
SD LED—SD Card Status
Table 11 SD LED
Label Color and State
SD0 Green
Green blinking
Amber solid
Amber blinking

Related Commands


show led, page 90

show led

To view the status of the router SYS LED, use the show led command in privileged EXEC mode. The SYS LED is located
on the router exterior (see
During normal operation, the router can be installed in a substation, utility box, or other hard-to-access location, and you
might not be able to view SYS LED. In this case, you can view the status of the LED from a remote location using the
show LED command.
The values displayed in the System LED field are described in
Description
SD flash card installed and operating normally
Note: If the SD Card is removed, the SD flash memory module LED remains green solid
until the router is rebooted.
SD flash card data transfer in process

Error when system accesses the SD flash card

Router cannot locate a system software image
Unsupported SD card installed in the slot
Figure 1 on page 86),
1
SYS LED—System Status, page
90
86.