Connected Grid Module Slots - Cisco 1120 Hardware Installation

Router Hardware Description
Hardware Features
Specifications
Specification
Connector type
Power consumption (from router)
Supported antenna
Kensington-Compatible Security Slot
See on page 17 for the Kensington-compatible security slot location.
The front panel features one Kensington-compatible security slot. Use this slot to secure the router at the installation
location with a Kensington (or compatible) security cable.
Dimensions
3.00

Connected Grid Module Slots

The router has two module slots to support up to two compatible Cisco Connected Grid modules that add NAN and LAN
interfaces to the router.

For more information about the Connected Grid modules for this router, see
page 67.

For detailed installation instructions for installing Cisco Connected Grid modules in the router, see the corresponding
installation and configuration guide for each module at:
Module Numbering
The router uses module numbering to identify the integrated and modular router components. Some system software
commands refer to the following module numbers.

Module 1 is the integrated router supervisor engine (located on the CPU motherboard)

Module 2 is the router integrated Ethernet switch module, which has six Fast Ethernet ports and two Gigabit Ethernet
ports.

Module 3 and Module 4 are external, Connected Grid modules installed in the router module slots with the
corresponding numbers (see
Description
Female QMA
3V (when GPS connectivity is active)
Cisco Product ID (PID): ANT-GPS-OUT-TNC
7.00
+.26
–.00
4 * R 1.00 max
on page 17).
+.26
–.00
www.cisco.com/go/cg-modules
21
About Connected Grid Modules,