Making Network Connections; Before Installing; Installation Site Preparation; Installation Safety Information - Cisco 1120 Hardware Installation

Making Network Connections

This section describes how to connect network and other connections when installing the Cisco 1120 Connected Grid
Router, and includes the procedures for basic router network connections and for optional installation steps. The
procedures you follow depend on your network environment and requirements.
These topics are discussed:

Before Installing, page 55

Basic Network Connections, page 56

Additional Router Connections, page 60

Installing Modules and Antennas, page 65
Note: This chapter describes router installation procedures. For detailed, technical information about the router
hardware, including hardware specifications and connector and cable descriptions, see
page 13 and Connector and Cable Specifications, page

Before Installing

Before following any installation procedures in this section, read these topics:

Installation Site Preparation, page 55

Installation Safety Information, page 55

Connecting the Router to Power, page 55

Preventing Electrostatic Discharge Damage, page 56

Cabling Guidelines, page 56

Installation Site Preparation

The procedures in this section assume that you prepared the installation site according to the information in
Safety and Site Preparation, page

Installation Safety Information

Before performing any of the tasks in this section, read the safety warnings in this section and in
Site Preparation, page
Connecting the Router to Power
Before you make network connections, your router should be connected to the AC power source and powered on as
described in Connecting the Router to Power, page
7.
7.
Cisco Systems, Inc.
95.
45.
www.cisco.com
55
Router Hardware Description,
Installation
Installation Safety and