Before You Begin; Verify Router Hardware Readiness; Tools And Materials You Supply - Cisco 1120 Hardware Installation

Connecting the Router to Power
This section describes how to connect the Cisco 1120 Connected Grid Router to AC and DC power source
These topics are discussed:

Before You Begin, page 45

AC Power Connection Information, page 47

Connect to AC Power, page 51

Connect to DC Power (Optional), page 52

Power Cycling the Router, page 53

Before You Begin

Before you connect power to the router, read these topics:

Verify Router Hardware Readiness, page 45

Tools and Materials You Supply, page 45

EMC Class A Notices and Warnings (US and Canada), page 46

Safety Information, page 47

Verify Router Hardware Readiness

Before connecting the router to power, verify the following:

The unit is grounded as described in

The SD flash memory module is installed correctly as described in

Tools and Materials You Supply

You must provide the following tools and materials to connect the router to AC power or optional DC power:
Note: For the AC power connector, a 5-way screw terminal printed circuit board plug connector manufactured by
Phoenix Contact (part number 1913604) is supplied.
Note: For the DC power connector, a 2-way screw terminal printed circuit board plug connector manufactured by
Phoenix Contact (part number 1912184) is supplied.

Wire-stripping tool

Flat-blade screwdriver
Mounting the Router, page
Cisco Systems, Inc. www.cisco.com
45
35.
Using the SD Flash Memory Module, page 79.