Cisco 1120 Hardware Installation page 38

2. Use the #2 Phillips screwdriver to remove the four large screws (Item 1,
Keep the screws. You will replace them at the end of this procedure to mount the bracket on the chassis.
3. Remove only the screws indicated in
router bottom panel to the chassis.
Figure 2 Remove the Four Large Screws (1) from the Router Base
1
4. Place the mounting bracket onto the back of the router, following these guidelines

The bracket handle (Item 3,

Align the bracket mounting holes (Item 2,
Figure 3 on page 39). (The screws were removed from the bracket connectors in Step 2.)
Figure 2 on page
Module Panel
Cable Panel
Figure 3 on page 39) should be facing the router cable panel.
Figure 3 on page
38
Figure 2 on page
38. Do not remove the smaller screws, which secure the
39) with the router bracket connectors (Item 1,
38) from the chassis base.
1
(Figure 3 on page 39):