Advertisement
Par.
Name
Stall Prevention
0:Disabled - Motor accelerates at
Stall
Prevention
L3-01
Selection
1:General Purpose - Hold
during
Accel.
2:Intelligent - Acceleration in the
Stall Prev.
Level
Sets the current level for stall
L3-02
during
prevention during acceleration.
Accel.
0:Disabled - Deceleration as set. ov
1:General Purpose - Deceleration
Stall Prev.
Selection
L3-04
during
2: Intelligent
Decel.
3: Stall Prevention with Braking
4: Overexcitation Deceleration
7: Overexcitation Deceleration 3
0:Disabled - Motor stall or
Stall Prev.
L3-05
Selection
1:Decel Time 1 - Reduce speed
during Run
Stall Prev.
Sets the current level at which stall
L3-06
Level
prevention during run starts to
during Run
operate.
Auto-Tuning
Auto-
0:Rotational Auto-Tuning
Tuning
2: Terminal resistance only
T1-01
Mode
3: Rotational Auto-Tuning for
Selection
Energy Saving
Rated
T1-02
Sets the motor rated power (kW).
Power
Rated
T1-03
Sets the motor rated voltage (V).
Voltage
Rated
T1-04
Sets the motor rated current (A).
Current
Base
Sets the motor base frequency
T1-05
Frequency
(Hz).
T1-06 Motor Poles Sets the number of motor poles.
T1-07 Base Speed
Sets the motor base speed (RPM).
Iron loss for determining the
Motor Iron
T1-11
Energy Saving coefficient.
Loss
If unknown leave it on default.
YASKAWA ELECTRIC TOEP C710606 15E - AC Drive V1000 - Quick Start Guide
Description
active acceleration rate and may
stall with too heavy load or too
short accel time.
acceleration when current is
above L3-02.
shortest possible time.
might occur.
is hold if DC bus voltage rises
high.
Resistor
overload might occur.
using C1-02.
Monitor
U1-01
Frequency Reference (Hz)
U1-02
Output Frequency (Hz)
U1-03
Output Current (A)
U1-05
Motor Speed (Hz)
U1-06
Output Voltage Reference (Vac)
U1-07
DC Bus Voltage (Vdc)
U1-08
Output Power (kW)
U1-09
Torque Reference (% of motor rated torque)
Input Terminal Status
Reserved
U1-10
Output Terminal Status
Reserved
U1-11
Drive Status
U1-12
U1-13
Terminal A1 input level
U1-14
Terminal A2 input level
6 Parameter Table
Description
: ON
: OFF
1: Digital input 1
(terminal S1 enabled)
1: Digital input 2
(terminal S2 enabled)
1: Digital input 3
(terminal S3 enabled)
1: Digital input 4
(terminal S4 enabled)
1: Digital input 5
(terminal S5 enabled)
1: Digital input6
(terminal S6 enabled)
: ON
: OFF
1: Relay Output
(terminal MA-MC closed
MB-MC open)
1: Open Collector Output 1
(terminal P1) enabled
1: Open collector Output 2
(terminal P2) enabled
1: During run
1: During zero-speed
1: During REV
1: During fault reset
signal input
1: During speed agree
1: Drive ready
1: During alarm detection
1: During fault detection
EN 31
Hide quick links:
Advertisement
