Saving Autotest Results - Fluke DSP-FTA420 User Manual

Saving Autotest Results

To save the results of the last Autotest, press S. Use the test tool's
alphanumeric display to enter one or two fiber names, depending on which
remote end configuration was used:
•
In Smart Remote Mode, the test tool saves two reports for each Autotest:
one for the fiber connected to the output port and one for the fiber
connected to the input port.
Enter a name for the fiber connected to the DSP-FTA output port; then
press S. Next, enter a name for the fiber connected to the input port;
then press S again.
•
In Loopback Mode and Far End Source Mode, the test tool saves one
report for each Autotest. Enter a name for the fiber; then press S.
You can edit the fiber identification assigned to a saved report as follows:
1. Turn the rotary switch to SPECIAL FUNCTIONS; select
View/Delete Test Reports, then press E.
Select the desired report, then press ! View Result twice (for the
2.
Far End Source Mode you only need to press ! View Result
once).
Press Rename Report. Use the alphanumeric display to edit the fiber
3.
identification; then press S.
You can edit a custom header, operator name, or site name in the PRINT mode
under Edit Report Identification.
Fiber Test Adapter
Saving Autotest Results
21